Setting Up Matrox Tweening (Blending)

Post date: Apr 28, 2016 3:41:6 PM

This guide assumes that the system is setup correctly...

If you go into edge overlap and it is greyed out, you need to run the initial setup first. 

To go to this guide first click here

Open the Matrox Application and Select "Edge Overlap and Bezel Management"

Select the display and click Modify

You need to select the middle display, and then increase the pixels in the available box in the bottom left until the numbers and diamonds line up perfectly (this needs to be checked onsite!!)

You can see that the final positions for aren't always necessarily the same.

Make sure you click OK, and then accept the changes by clicking YES.